Security vibration friction welding machine
1. The machine should have a good grounding protection drums, allowed unauthorized overhaul.
2. To clean the oil in time, back to the kerosene can not overfilled, put, reclaimer should be careful.
3 Before startup, press equipment lubrication chart oiling, check the oil standard oil level or grease points.
4. Start the pump motor, collet clamp the workpiece, adjust the hydraulic system pressure, working pressure, clamping pressure, the top forging force, checking headstock lubrication.
5. In the adjustment of status, adjustment slide, turret movement speed and distance.
6. Check the headstock lubrication, clutch, brake, low speed spindle.
7 before shutdown reset, shut down the spindle motor, until the spindle stops, shut the pump motor.
8. Close the machine electronically controlled switch, turn off the air switch cabinet.
9. Clean the machine, press equipment lubrication chart or oiling oiling points.
10. Do wear slippers, sandals, shorts and a half operation, to prevent iron burns, non-gloved hands.
11. The anti-rotation block jig must lock to prevent the anti-rotation screw or block off.
12. The application of specialized wrench handling fixtures, allowed the cone deformation of the spring loaded clamps use.
13. Fast forward, rewind can not be stressed too fast, to prevent danger, critical proper belt tension, shields shall be locked.
14. flash before cutting the amount should be small to large, work into should be appropriate.
15. The operator must undergo training, examination or assessment of qualified certificates.
16. The operator must be familiar with the sequence of operations and performance of the machine, prohibited the use of ultra-performance equipment.